Dakota Digital LAT-NR362 Fascicule
INSTALLATION INSTRUCTIONS
LAT-NR362
LED Tail Lights for 1967-1968 Mustang
MAN#650205
Kit Includes:
Installation:
1. Remove light bulb socket from the back of the tail light housing.
2. Remove the light bulb from socket.
3. Remove 6 nuts from the trim studs that secure the tail light housing.
4. Pull the trim pieces out of tail light housing from the rear of vehicle.
5. Remove tail light housing from vehicle.
6. Pull the body seal out of the tail light housing up over the lens.
2. Remove the light bulb from socket.
3. Remove 6 nuts from the trim studs that secure the tail light housing.
4. Pull the trim pieces out of tail light housing from the rear of vehicle.
5. Remove tail light housing from vehicle.
6. Pull the body seal out of the tail light housing up over the lens.
7. Remove the 6 lens mounting screws.
8. Remove the lens from the housing.
9. Loosen the lens seal from the housing by gently pulling the seal away from the housing.
8. Remove the lens from the housing.
9. Loosen the lens seal from the housing by gently pulling the seal away from the housing.
10. Clean dirt and rust from the seal surface of the housing. Now is a good time to clean and
inspect the lenses also. If the lenses are in bad shape, a replacement set is recommended.
MAN#650205