ADT Security Services SAVS20ADT-1 Manuel D’Utilisation

ARMING PERIMETER ONLY 

(With Entry Delay ON)

 

 

3     

BEFORE ARMING,
close all doors and windows
(see 

CHECKING FOR OPEN

ZONES ).

 THE  STAY MODE ARMS
 THE PERIMETER, BUT
 ALLOWS USE OF THE
 ENTRY/EXIT DOOR.
 PERSONS WITHIN THE
 PREMISES CAN MOVE
 ABOUT FREELY.

 

† Ask your installer if this

feature is programmed in
your system. If so, place a
check in this box.   

    

Use this key when  staying inside, but expect someone to use an entry/exit door later. It is
also useful if you are leaving but someone is staying inside (or if you have pets which are
moving throughout the premises.
1. Enter your security code and press the STAY [3] key. In some systems, pressing

the “B” key on on the touchpad for 2 seconds will arm the system STAY (no code is
required). The “B” key may or may not have been programmed for this. Check with
your installer.

2. The touchpad beeps three times and displays the armed STAY message (see

displays below). The red ARMED indicator also lights. Note that there is an 

exit delay

in effect before arming actually takes place. See the note below.

3. After arming, an alarm sounds immediately if a protected perimeter window or non-

entry/exit door is opened, but you may otherwise move freely within the premises.

Anyone entering later can enter through an entry/exit door without causing an alarm, but
they must disarm the system within the 

entry delay period to avoid sounding an alarm.

† 

 

 If you wish to open the entry/exit door to let someone in after

arming STAY, you can re-start the 

exit delay at any time – simply press the [

✱

] key,

then let that person in. This avoids having to disarm the system and then re-arm it again.

When you first arm in the STAY mode, “

 will be displayed on a Custom

Display Touchpad during the programmed exit delay. 

This delay is in effect even when

arming STAY.  When “

” disappears, the system is fully armed.

ARME D  

***

STAY 

***

YOU   M AY   E XIT  NOW