Panasonic SC-HTB351 Manuel D’Utilisation

RQT9670

∫ Remote control code

When other Panasonic devices respond to this system’s 
remote control, change the remote control code on the 
main unit and the remote control.

≥ Turn off all other Panasonic products.
≥ Turn on the main unit.

Change the remote control code to code 2:
1

Aim the remote control at this system’s remote 
control sensor.

2

Press and hold [MUTE] and [

] on the remote 

control for more than 4 sec.

≥ All the indicators will blink for 10 sec when the code of 

this system is changed.

≥ The setting is maintained until it is changed again.

≥ If this system does not operate after changing the code, 

repeat steps 1 and 2.

≥ To change the remote control code to code 1, repeat the 

steps above, but replace 

[

] 

with [TV]. 

∫ To reduce the clear-mode dialog effect

When the dialog does not sound natural while the volume 
is set low, for example, It is possible to reduce the dialog 
enhancing effect as follows:
Press and hold [TV] on the remote control and followed by 
[s VOL] on the main unit for more than 2 sec.

≥ All the indicators will blink once when the clear-mode dialog 

effect is reduced.

≥ Even if clear-mode dialog effect is reduced, dialog effect 

level is still adjustable.

∫ To turn off the volume limitation

If a state of the lowered volume disturbs you every time 
this system turns on, for example, it is possible to turn off 
this function as follows:
Press and hold [MUTE] on the remote control and 
followed by [VOL r] on the main unit for more than 2 sec.

≥ All the indicators will blink once when the volume limitation 

is turned off.

The settings of the clear-mode dialog effect and the volume 
limitation remain intact even if you switch this system to 
standby mode. To turn these 2 functions back on, this system 
must be set back to the factory preset. (> 26)

SC-HTB351_RQT9670_mst.book  Page 25  Tuesday, March 6, 2012  7:22 PM