ONKYO 29344937 Manuel D’Utilisation

58

Operating Notes: 
• Before selecting a different input source, stop iPod or 

iPhone playback to prevent the AV receiver from 
selecting the iPod or iPhone input source by mistake.

• If any accessories are connected to your iPod or 

iPhone, the AV receiver may not be able to select the 
input source properly.

• While your iPod or iPhone is in the UP-A1 series 

Dock, its volume control has no effect. If you adjust 
your iPod or iPhone models volume control while it’s 
in the UP-A1 series Dock, make sure it’s not set too 
high before you reconnect your headphones.

■ Using Your iPod or iPhone models Alarm 

You can use your iPod or iPhone models Alarm Clock 
function to automatically turn on your iPod or iPhone 
and the AV receiver at a specified time. The AV 
receiver’s input source will automatically be set to the 
[PORT] selector.

Notes:
• To use this function, your iPod or iPhone must be in 

the UP-A1 series Dock, and the UP-A1 series Dock 
must be connected to the AV receiver.

• When you use this function, be sure to set the AV 

receiver’s volume control to a suitable level.

• The AV receiver may take several seconds to startup, 

so you might not hear the first few seconds of the first 
song.

■ Charging Your iPod or iPhone models 

The UP-A1 series Dock charges your iPod or iPhone 
models battery while your iPod or iPhone is in the UP-
A1 series Dock and connected to the UNIVERSAL 
PORT jacks on the AV receiver. While your iPod or 
iPhone is seated in the UP-A1 series Dock, its battery 
will be charged when the AV receiver is set to “On” or 
“Standby”.

Note:
When UP-A1 series Dock that seated iPod or iPhone is 
connected, the power consumption on standby mode 
slightly increases.

By pressing the REMOTE MODE button that’s been 
programmed with the remote control code for your 
Dock, you can control your iPod or iPhone in the Dock 
with the following buttons.
The [PORT] button is preprogrammed with the remote 
control code for controlling a Dock with Universal Port 
connector.
For details on entering a remote control code, 
see page 84. 

When Using a Dock with Universal Port connector:
• Connect the Dock to the UNIVERSAL PORT jack.
• See to the Dock’s instruction manual for more infor-

mation.

You can control your iPod or iPhone when “PORT” is 
selected as the input source.

Note:
For detailed operation of the iPod or iPhone, please refer 
to the instruction manual.

h

g

k

j

l
m
n

i

a

f

b

d

c

e

o