Runco Home Theater Projection System Manuel D’Utilisation
LightStyle™ LS-12HBd Installation/Operation Manual
49
PRE
L
IMINAR
Y
Connecting the Active 3D
Emitter to the Dimension
Digital Controller
Emitter to the Dimension
Digital Controller
Connect the 3D SYNC Out port on the emitter to the 3D Sync Out connector on the
Dimension Digital Controller, as shown in Figure 3-21. Mount the emitter in a location that
provides a clear line of sight between it and the viewing area.
Dimension Digital Controller, as shown in Figure 3-21. Mount the emitter in a location that
provides a clear line of sight between it and the viewing area.
Figure 3-21. Active 3D Emitter Connection
Connecting to AC Power
Projector: Plug the female end of one power cord into the AC receptacle on the rear of
the LS-12HBd (AC 100V ~ 240V). Then, connect the other end to your AC power source.
the LS-12HBd (AC 100V ~ 240V). Then, connect the other end to your AC power source.
Anamorphic Lens Transport: An
AC-to-DC power adapter is provided for
the lens transport. Connect the power
adapter to the +9V DC In jack on the
rear of the lens transport assembly.
Connect the other end to an AC power
source.
AC-to-DC power adapter is provided for
the lens transport. Connect the power
adapter to the +9V DC In jack on the
rear of the lens transport assembly.
Connect the other end to an AC power
source.
Similarly connect the Dimension Digital Controller to a nearby AC outlet.
Secure the emitter in the desired location using double-sided tape or
a similar adhesive material.
a similar adhesive material.
Tip
USB
Video 1
Y
Video 2
Video 3
Pr
Pb
HDMI 2
Component / SCART
TRIGGERS
1
2
3
HD1
3D SYNC
HD2
DisplayPort
USB
Video 1
Y
Video 2
Video 3
Pr
Pb
HDMI 2
Component / SCART
TRIGGERS
1
2
3
HD1
HD2
DisplayPortrr
Active 3D Emitter
3D
SYNC IN