Sony HT-AS5 Manuel D’Utilisation
37
GB
T
u
n
e
r Op
era
tio
ns
1
Press TUNER repeatedly to
select the FM or AM band.
select the FM or AM band.
You can also use INPUT SELECTOR on
the subwoofer.
the subwoofer.
2
Press and hold TUNING +/–
until the auto scanning starts.
until the auto scanning starts.
Press TUNING + to scan from low to
high frequency; press TUNING – to scan
from high to low frequency.
The system stops scanning whenever a
station is received. To stop the Auto
Tuning manually, press TUNING +/–.
high frequency; press TUNING – to scan
from high to low frequency.
The system stops scanning whenever a
station is received. To stop the Auto
Tuning manually, press TUNING +/–.
If an FM program is noisy
If an FM program is noisy, you can select
monaural reception. There will be no stereo
effect, but reception will improve.
monaural reception. There will be no stereo
effect, but reception will improve.
1
Press MENU/HOME.
2
Press
V/v repeatedly until “FM
MODE” appears, then press
or
b.
3
Press
V/v repeatedly until
“MONO” appears, then press
.
• STEREO: Stereo reception.
• MONO: Monaural reception.
The initial setting is “STEREO”.
• MONO: Monaural reception.
The initial setting is “STEREO”.
4
Press MENU/HOME.
Tip
To improve reception, reorient the supplied
antennas (aerials).
antennas (aerials).
Enter the frequency of a station directly by
using the numeric buttons.
using the numeric buttons.
1
Press TUNER repeatedly to
select the FM or AM band.
select the FM or AM band.
You can also use INPUT SELECTOR on
the subwoofer.
the subwoofer.
2
Press D.TUNING.
3
Press and hold SHIFT, then
press the numeric buttons to
enter the frequency.
press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
Select 1
Select 1
t 0 t 2 t 5 t 0
Example 2: AM 1,350 kHz
Select 1
Select 1
t 3 t 5 t 0
If you have tuned in an AM station, adjust
the direction of the AM loop antenna
(aerial) for optimum reception.
the direction of the AM loop antenna
(aerial) for optimum reception.
4
Press and hold SHIFT, then
press ENTER.
press ENTER.
If a wrong frequency is entered
“FM ---.--” or “AM ----” appears and then the
display returns to the current frequency.
display returns to the current frequency.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
Tuning into a station
automatically (Auto Tuning)
automatically (Auto Tuning)
Tuning into a station directly
(Direct Tuning)
(Direct Tuning)