Wolf DCX-500FD Manuel D’Utilisation

Wolf Cinema Owner's Manual

2-1

The  instructions  provided  here  are  for  those  that  are  familiar  with  the  projector  and  wish  to 
quickly set it up and use it temporarily. refer to the remaining subsections of this manual for a 
more complete setup.

Install the Projection Lens
The projection lens is shipped separately from the projector and must be installed prior to setting 
up the projector. install the projection lens as described in 4.5 Replacing the Projection Lens.

 Remove the lens plug from the lens opening in the projector before installing the lens.

 Remove the lens when shipping the projector and reuse the lens plug to prevent dust 

and debris from entering and settling on critical optical components.

Position the Projector
Place  the  projector  on  a  sturdy,  level  surface  and  position  it  so  that  it  is  perpendicular  to  the 
screen at a suitable distance. in general, the further back the projector is positioned from the 
screen, the larger the image will be.

if required, you can level the projector by adjusting its three feet. With the projector positioned 
perpendicular to the screen the image will appear rectangular instead of keystoned.

For  more  detailed  instructions  on  positioning  the  projector  refer  to  Projector  Position  and 
Mounting later in this section.

Connect a Source
located at the back of the projector is the input panel where all source connections are made. 

Each input is clearly labeled for easy identification.

Using the appropriate cable(s), connect your source. Connect rGB and yPbPr sources to InPUT 
1 located in the upper right corner of the input panel. Use the DVi-i connector at  InPUT 2 to 
connect analog or digital display signals. Connect composite video to InPUT 3 and S-Video to 
InPUT 4. 

nOTe: One of the available optional input modules can be installed at InPUT 5 or InPUT 6 for 
additional connections.

refer to 2.3 Connecting Sources

for more details on connecting a specific source.