HP (Hewlett-Packard) 2307890A Manuel D’Utilisation

You may have to perform the Adjusting the Desktop 
Display procedure before and after playing a commercial 
DVD video in component video, due to copy protection 
measures.

To play a commercial DVD video in component video, the 
resolution format must be set to 480i or 480p. The DVD 
will not play after it is inserted into the drive, and you 
may see an error message when you try to play the DVD 
in component video and the resolution format is set above 
480i or 480p.

To play a commercial DVD video, in component video, in 
Media Center:

Press Media Center on the remote control.

You can also click Start on the taskbar, and 
select Media Center.

Click More Programs, HP Settings, and then 
Video Settings.

Click DVD Mode (480p). (Select this mode only if 
your TV supports 480p mode.) 

After playing the commercial DVD video in 
component video, perform the Adjusting the Desktop 
Display procedure to return the desktop image and 
Media Center to a higher resolution format. See 
“Adjusting the Desktop Display” on page 143.

You can also use the following procedures to adjust the 
TV video settings. These procedures are examples only 
and may vary depending on your TV/display type, 
supported formats, and video out connections. You may 
have to perform the procedure more than once to 
optimize the image.

You can use this window to adjust the TV video image in 
component video out. This window is not available for 
single displays in HDMI, DVI, or VGA video out. Use the 
Media Center HP Settings wizard to adjust these displays.

Before you begin, verify that the video equipment is 
properly connected to the HP Digital Entertainment Center 
and turned on, and ensure that your TV screen is set to 
normal mode (not letter-box, wide or re-sized).

n