Daewoo DR-C922B Manuel D’Utilisation

Page de 66
9
Product
Information
Identification of Controls 
Rear Panel
Power Cord 
Jack for supplying power to the unit. Connect to a
wall outlet. 
5.1 Speaker Out Jack 
Connect each of the speaker wires to the satellite
speakers. Speaker cords, 1 for each speaker, are
needed for connection. When connecting the
speakers, make sure the polarities ("+" side of the
speaker wire to "+" on the receiver) of speaker
wires and terminals are matched.  
Connection to Antenna Cable 
Connect a coaxial cable from your cable wall
outlet or antenna to the ANT IN jack on the back
of your DVD/VCR unit.
AM Antenna Jack 
S-Video Output Jack (DVD only)
COMPONENT (Progressive) Out Jack (DVD
only)
To obtain better screen quality, connect the unit
to a TV or monitor with a COMPONENT(480i or
480p) input.
Note: VCR signal is only available from Composite Video
Out jack and RF Out. You must always connect these to
the TV in order to set up and use your unit.
Subwoofer Pre-Output Jack  
Connect an active subwoofer to improve bass
performance especially in a large room.
A/V Output Jack 
A/V Input 2 Jack 
A/V Input 1 Jack 
Connection to TV 
Required connection for VCR operation. Connect
one end of the RF cable to the RF Out Jack on the
back of the unit and the other end to the ANT IN
jack on the back of your TV.
FM Antenna Jack 
@
!
# $
%
&
*() 1 2
^
DR-C91/92D1N-BS  04.1.19 9:51 PM  ˘
`
9