Shindaiwa 80732 Manuel D’Utilisation

15

PB2500.20

If the engine becomes sluggish and low
on power, check and clean the spark
arrester screen.

Never operate the unit with a dam-
aged or missing muffler or spark
arrester! Operating with a missing or
damaged spark arrester is a fire
hazard and could also damage your
hearing.

1. With a 3 mm hex wrench remove the

4 engine cover screws and the engine
cover. See Figure 28.

2. With a 4 mm hex wrench remove the

3 muffler bolts and the muffler.
See Figure 28.

3. With a small flat bladed screwdriver

remove the 2 screws holding the
spark arrester screen and cover to
the muffler. See Figure 28.

If you note excessive carbon buildup,
consult with an authorized Shindaiwa
servicing dealer.

4. Remove the screen and clean it with a

stiff bristle brush.

5. Inspect the cylinder exhaust port for

any carbon buildup.

6. Reassemble the spark arrester, muffler

and engine cover in the reverse order
of disassembly.

Muffler

Bolts

Spark Arrester

Screen

Cover

Cover Screws

Muffler

Gasket

Engine Cover

Screws

Muffler

Spark Arrester

Cover

PB2500.21

PB2500.22

BURN DANGER! The gearcase will
be extremely hot after use!

The gearcase should be filled with 60 cc
(2.0 fl.oz.) of Mobil SHC634 Synthetic
Gear Oil. A maximum of 75-80 cc can be
used, but never to exceed 80 cc. Opera-
tion with excessive oil level will result in
high operating temperatures. Do not
overfill!

Fill to

this level

correct oil depth is 5/8" (15.5 mm).
See Figure 30.  DO NOT OVERFILL!

6.  Inspect the sideplate for damage and

clean off all remaining liquid gasket
material with brake cleaner or acetone.
Coat the outer sealing flange of the
sideplate with Loctite Ultragrey Silicon
Sealant  or Threebond  No. 1104
Liquid Gasket.

7.  Replace the cover and install the four

sideplate screws. Tighten securely.

8.  Reinstall the drum and axle assembly

per the sweeper assembly instructions.
See page 9.

1.  Disconnect spark plug wire at engine.

2.  Remove the LH Drum and axle

assembly (as viewed from the operat-
ing position). Wipe the sideplate clean
and remove four screws (it is not
necessary to remove the gearcase
from the outer tube).

3.  Turn gearcase side plate to break the

seal and lift the plate from the gear-
case. See Figure 29.

It may be necessary to use a heat gun to
soften the sealer material.
4.  Turn the gearcase to the LH side and

allow all used gearcase oil to drain into
a small container and properly dispose
of as in accordance with your local
regulations.

5.  Place the gearcase on the RH side and

supported so the outer tube is parallel
to the ground. Refill the gearcase with
60 cc (2.0 fl.oz) of Mobil SHC634
Synthetic Gear Oil to the bottom of the
chamfer on the output gear. The

BURN DANGER! The engine will
become very hot during normal
operation. Let engine cool before
servicing.