Shindaiwa 80732 Manuel D’Utilisation

18

Poor acceleration.

Clogged air filter.

Clogged fuel filter.

Lean fuel/air mixture.

Idle speed set too low.

Clogged spark arrester.

Clean the air filter.

Replace the fuel filter.

Consult with an authorized servicing dealer.

Adjust: 3,200 (

Ⳳ300) rpm (min

-1

).

Clean spark arrester. (Pg. 15).

Engine stops abruptly.

Switch turned off.

Fuel tank empty.

Clogged fuel filter.

Water in the fuel.

Shorted spark plug or loose terminal.

Ignition failure.

Piston seizure.

Reset the switch and restart.

Refuel. See page 10.

Replace fuel filter.

Drain; replace with clean fuel. See page 10.

Clean and replace spark plug, tighten  
the terminal.

Replace the ignition unit.

Consult with an authorized servicing dealer.

Engine difficult to shut off.

Ground (stop) wire is disconnected or  
switch is defective.

Overheating due to incorrect spark plug.

Overheated engine.

Test and replace as required.

Idle engine until cool.
Clean and regap the plug to 0.024 - 0.028 
inch (0.6 - 0.7 mm). Correct plug: NGK CMR6H 
or equivalent resistor type spark plug of the 
correct range.

Idle engine until cool.

Sweeping attachment 
rotates at engine idle.

Engine idle too high.

Broken clutch spring or worn clutch  
spring boss.

Loose attachment holder.

Set idle: 3,200 (

Ⳳ300) rpm (min

-1

)

Replace spring/shoes as required, check  
idle speed.

Inspect and re-tighten holders securely. 

Engine will not idle down.

Engine idle set too high.

Engine has an air leak.

Set idle: 3,200 (

Ⳳ300) rpm (min

-1

)

Consult with an authorized servicing dealer.

Top of engine is getting  
dirty and oily.

Valve cover is leaking.

Consult with an authorized servicing dealer.

Excessive vibration.

Warped or damaged sweeper attachment.

Loose gearcase.

Bent main shaft/worn or damaged  
bushings.

Inspect and replace attachment as required.

Tighten gearcase securely.

Inspect and replace as necessary.

Sweeper belts will  
not rotate.

Shaft not installed in powerhead or 
gearcase.

Broken shaft.

Damaged gearcase.

Inspect and reinstall as required.

Consult with an authorized servicing dealer.

Consult with an authorized servicing dealer.