Shindaiwa 82052 Manuel D’Utilisation

19

Tools required:     Cross Head Screwdriver, 3 mm Hex Wrench, soft 

metal brush

Spark arrestor screen, Gasket 

IMPORTANT  

Carbon deposits in muffler will cause a drop in engine output and 
overheating.  Spark arrestor screen must be checked periodically.

  1.  Remove spark plug lead and spark plug.

  2.  Remove two upper 3 mm hex screws at recoil starter.

  3.  Remove five engine cover screws and remove cover from engine.  

  4.  Remove spark arrestor covers (A, B), gasket (C) and spark ar-

restor screen (D) from muffler.  Replace screen if plugged with 
carbon deposits.

NOTE
When cleaning carbon deposit, be careful not to damage the cata-

lytic element inside muffler.

  5.  Install spark arrestor screen, gasket, and covers.

  6.  Loosely reassemble engine cover with five cross head and two 

hex head screws.

  7.  Tighten all screws securely.

  8.  Install spark plug and spark plug lead.

  1.  Remove spark plug lead and spark plug.

  2.  Remove four 3 mm hex screws, side handle and recoil starter.

  3.  Remove engine cover (five screws), pull cover away from engine. 

Loosely install spark plug to prevent dirt from entering cylinder. 

Clean cylinder fins to allow cooling air to pass freely.

  4.  Remove spark plug and loosely reassemble engine cover, recoil 

starter, and side handle.

  5.  Tighten all screws securely.

  6.  Install spark plug and spark plug lead.