Troy-Bilt TB 2454 Hydro Manuel D’Utilisation

The hardware for attaching the steering wheel has been packed 

within the steering wheel, beneath the steering wheel cap. 

Carefully pry off the steering wheel cap and remove the hardware.
1. 

With the wheels of the tractor pointing straight forward, align 

the steering wheel by using the center-line on the front of the 

steering wheel pointing straight ahead and the flat section of 

the steering wheel facing toward the seat, place the steering 

wheel over the steering shaft. See Figure 3-6.

2. 

Secure the steering wheel with the hex bolt from under the 

cap and torque to 18-22 ft.-lbs. 

3. 

Place the steering wheel cap over the center of the steering 

wheel and push downward until it “clicks” into place.
NOTE: If the bolt securing the steering wheel is removed, it 

is recommended that the bolt be replaced.

The hardware for attaching the front bumper is shipped installed 

into the bumper.
1. 

Remove the four hex screws from the bumper.

2. 

Position the bumper brackets to the inside of the tractor’s 

frame and secure it in place with the four hex flange 

screws. See Figure 3-7.

To adjust the position of the seat, lift the seat adjustment lever 

up. Slide the seat forward or rearward to the desired position; 

then release the adjustment lever. Make sure seat is locked into 

position before operating the tractor. See Figure 3-8.