Troy-Bilt TB 2454 Hydro Manuel D’Utilisation

The REVERSE CAUTION MODE 

 position of the ignition 

module allows the tractor to be operated in reverse with the 

blades (PTO) engaged.

NOTE: Mowing in reverse is not recommended.

Use extreme caution while operating 

the tractor in the REVERSE CAUTION MODE 

. 

Always look down and behind before and while 

backing. Do not operate the tractor when children 

or others are around. Stop the tractor immediately if 

someone enters the area.

To use the REVERSE CAUTION MODE 

:

NOTE: The operator MUST be seated in the tractor seat.
1. 

Start the engine as previously instructed on the previous 

page.

2. 

Turn the key from the NORMAL MOWING 

(Green) 

position to the REVERSE CAUTION MODE 

 (Yellow) 

position of the ignition module. See Figure 5-1.

3. 

Press the REVERSE PUSH BUTTON 

 at the top, right 

corner of the ignition module. The red indicator light at 

the top, left corner of the ignition module will be ON while 

activated. See Figure 5-1.

4. 

Once activated (indicator light ON), the tractor can be 

driven in reverse with the cutting blades (PTO) engaged.

5. 

Always look down and behind before and while backing to 

make sure no children are around. After resuming forward 
motion, return key to the NORMAL MOWING 

 position.

The REVERSE CAUTION MODE 

 will remain activated until:

a.  The key is placed in either the NORMAL MOWING 

 position or STOP   position or

b.  The operator leaves the seat.

Avoid sudden starts, excessive speed 

and sudden stops. 

 

1. 

Lightly press the brake pedal  to release the parking brake. 
Move the throttle into the FAST 

 position.

2. 

To travel FORWARD, slowly press the forward drive pedal  

forward until the desired speed is achieved. See Figure 5-2.

3. 

To travel in REVERSE, check that the area behind is clear then 

slowly depress the reverse drive pedal  until the desired speed 

is achieved. See Figure 5-2.

Do NOT attempt to change the 

direction of travel when the tractor is in motion. 

Always bring the tractor to a complete stop before 

changing from forward to reverse or vice versa.

Do not leave the seat of the tractor 

without first placing the PTO in the DISENGAGED 

(OFF) position and engaging the parking brake. If 

leaving the tractor unattended, also turn the engine 

off and remove the ignition key.