Nilfisk-Advance America RS 501 Manuel D’Utilisation
SERVICE MANUAL
ENGLISH
RS 501
33015500(3)2008-02
31
DUST AND DEBRIS COLLECTION SYSTEM
SUCTION INLET WHEEL DISASSEMBLY/ASSEMBLY
NOTE
To remove the rear wheel (C), the machine must be lifted with an appropriate hoisting system. Otherwise, remove the
suction inlet assembly (D) according to the procedure shown in the relevant paragraph. See the following disassembling
procedures.
To remove the rear wheel (C), the machine must be lifted with an appropriate hoisting system. Otherwise, remove the
suction inlet assembly (D) according to the procedure shown in the relevant paragraph. See the following disassembling
procedures.
Front wheels (A) and (B) removal/installation
Engage the parking brake with the lever (66).
Lift the suction inlet (12), according to the procedure shown in the User Manual.
Turn the ignition key (76) to OFF position and remove it.
On both sides of the machine, loosen the screws (E) and (F), then remove the front wheels (A) and (B).
Install the new front wheels (A) and (B) and fasten them with the screws (E) and (F).
If necessary, perform the suction inlet and skirt height and operation check (see the procedure in the relevant paragraph).
Lift the suction inlet (12), according to the procedure shown in the User Manual.
Turn the ignition key (76) to OFF position and remove it.
On both sides of the machine, loosen the screws (E) and (F), then remove the front wheels (A) and (B).
Install the new front wheels (A) and (B) and fasten them with the screws (E) and (F).
If necessary, perform the suction inlet and skirt height and operation check (see the procedure in the relevant paragraph).
Front wheels (A) and (B), and rear wheel (C) removal/installation
Place the machine on the appropriate hoisting system (if present) and lift it.
If the hoisting system is not available, remove the suction inlet assembly (D) (see the procedure in the relevant paragraph).
Remove the screws (E), (F) and (G), then remove the wheels (A), (B) and (C).
Install the new wheels (A), (B) and (C) and fasten them with the screws (E), (F) and (G).
Perform step 1 again.
If necessary, perform the suction inlet and skirt height and operation check (see the procedure in the relevant paragraph).
If the hoisting system is not available, remove the suction inlet assembly (D) (see the procedure in the relevant paragraph).
Remove the screws (E), (F) and (G), then remove the wheels (A), (B) and (C).
Install the new wheels (A), (B) and (C) and fasten them with the screws (E), (F) and (G).
Perform step 1 again.
If necessary, perform the suction inlet and skirt height and operation check (see the procedure in the relevant paragraph).
G
A
D
B
C
F
E
S301485
1.
2.
3.
4.
5.
6.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
9.
10.
11.