Nilfisk-Advance America RS 501 Manuel D’Utilisation
SERVICE MANUAL
ENGLISH
RS 501
33015500(3)2008-02
81
LDW 1603/B2 ENGINE
FUEL FITTING AND SCREW CHECK
Empty the hopper (3); if it contains a small quantity of waste, it is not necessary to dump it.
Drive the machine on a solid and level ground, then engage the parking brake with the lever (66).
Lift the hopper (3), according to the procedure shown in the User Manual.
Turn the ignition key (76) to OFF position and remove it.
Open the left lid (18) by releasing the fasteners (19) with the supplied key.
Remove the locking pins (28) from the housings (29) and place them into the holes (30).
Empty the dust control system water tanks (7 and 16) according to the procedure shown in the relevant paragraph.
Remove the screw (42) and open the left tank (41).
Drive the machine on a solid and level ground, then engage the parking brake with the lever (66).
Lift the hopper (3), according to the procedure shown in the User Manual.
Turn the ignition key (76) to OFF position and remove it.
Open the left lid (18) by releasing the fasteners (19) with the supplied key.
Remove the locking pins (28) from the housings (29) and place them into the holes (30).
Empty the dust control system water tanks (7 and 16) according to the procedure shown in the relevant paragraph.
Remove the screw (42) and open the left tank (41).
WARNING!
Open the tanks (7 and 16) only if they are empty: each tank contains 120 kg of water approximately.
Open the tanks (7 and 16) only if they are empty: each tank contains 120 kg of water approximately.
Operating on the fuel fi lter (A) and on the diesel engine, check the sealing of fuel system fi ttings (B). Repair if necessary.
Operating on the fuel tank (C), check the sealing of fuel system fi ttings (D). Repair if necessary.
Perform steps 3, 4, 5, 6 and 8 in the reverse order.
If necessary, fi ll the dust control system water tanks according to the procedure shown in the User Manual.
Operating on the fuel tank (C), check the sealing of fuel system fi ttings (D). Repair if necessary.
Perform steps 3, 4, 5, 6 and 8 in the reverse order.
If necessary, fi ll the dust control system water tanks according to the procedure shown in the User Manual.
B
B
B
B
B B
D
C
D
A
S301656
1.
2.
3.
4.
5.
6.
7.
8.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
10.
11.
12.