Nilfisk-Advance America 56264401 Manuel D’Utilisation

FORM NO. 56041590 / AX 300 / AX 400 - 13

Once a month, wipe the solution valve with a clean cloth.  Then use a spray silicone lubricant on all pivot points associated with the valve
assembly, especially the valve plunger.
Once a month, lubricate the pivot points of the handle and the wheel axles.  Wipe off any excess to avoid staining floor surfaces.

The Solution Valve Assembly is located on the bottom of the machine.

Valve Plunger

Once a month, check the vacuum motor to make sure the airways are not blocked.  Clean the dome lid on the recovery tank thoroughly.
Clear hoses of debris and keep the vacuum motor exhaust area clean.

Vacuum Exhaust

Float Ball and Cage

Vacuum Hose

Dome Lid

Recovery Hose

Recovery Hose

Vacuum Exhaust

Pick Up Tool

Have Nilfisk check the carbon motor brushes once a year or after 500 operating hours.  Replace the carbon brushes if they are worn to 9.5
mm or less.

Motor damage from failure to service the carbon brushes is not covered under warranty.