Nilfisk Alto R 580 B Manuel D’Utilisation

146 2601 000(1)2005-03 A

FLOORTEC R 580 B

For further information, refer to the Service Manual, 
available at any Nilfisk-Alto Service Center.

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove the following 
components:
–

Battery

–

Polyester dust filter

–

Main and side brooms

–

Hydraulic oil

–

Hydraulic oil filter

–

Electronic boards

–

Plastic components and hoses

After having turned the ignition 
key (18, Fig. B) to “I” position, the 
display does not illuminate and 
the machine does not work.

Check that the battery 
connector (4, Fig. V) is correctly 
connected to the machine.

Check the F1 (1, Fig. Z) and F0 
(2, Fig. Z) fuse integrity

The machine does not move 
when pressing the accelerator 
pedal.

Turn the ignition switch to “0” 
position, then turn it to “I” 
position being careful not to 
activate the accelerator pedal 
during this operation

The main broom does not work

Check that the related fuse (5, 
Fig. V) is not deactivated; 
otherwise reactivate it by means 
of the related key

The side brooms do not work

Check that the related fuse (6 or 
7, Fig. V) is not deactivated; 
otherwise reactivate it by means 
of the related key

The machine operates only when 
stationary, otherwise the red 
warning light turns on.

Re-charge the battery. If the 
problem persists, replace the 
battery.

The machine collects little 
debris/dust

Check if the dust filter (4, Fig. N) 
is clogged

Check if the hopper (4, Fig. C) is 
full

Check that the skirts (16, 17, 18, 
19, Fig. C) are not broken or 
incorrectly adjusted

Check if the brooms (10, 11, 12, 
Fig. C) are at the correct height

The battery autonomy is low

Install a battery with greater 
capacity: 240 Ah

The hopper does not lift

Check the fuse (F2, Fig. Z) 
integrity

The hopper does not lift

Check the fuse (F3, Fig. Z) 
integrity

Check that the hopper is lifted 
from the ground at an height 
greater than 270 mm

The hopper does not lower

Before lowering the hopper by 
means of the related switch (15, 
Fig. B), check that the hopper 
has returned to the horizontal 
position by means of the related 
switch (16, Fig. B).

The filter-shaker does not work

Check that the main broom is 
lifted with the lever (24, Fig. B)

Check the fuse (F4, Fig. Z) 
integrity