Rubbermaid WD12.5G Manuel D’Utilisation

Attach tank brace to wheel shaft support using small screws,  

star washers, and small nuts. Use 10 mm socket wrench 

and box end wrench to fully tighten. FULLY TIGHTEN ALL 

Attach caster brackets to front of cart frame using small 

screws, star washers, and small nuts. Ensure open end of 

caster brackets face down. Use 10 mm socket wrench and 

box end wrench to fully tighten.

9

Attach axle support to cart frame using small screws, star 

washers, and small nuts. Hand tighten.

Turn cart frame over. Note orientation of notch in axle support.

Align diagonal supports with holes on side of cart frame (while 

ensuring spring loaded buttons face inside of cart). Attach diagonal 

supports to cart frame using small screws, star washers, and small 

nuts. Hand tighten.

Attach vertical supports to side of cart frame using small screws, 

star washers, and small nuts. Ensure support nests are pointed 

towards front of cart. Hand tighten. 

Attach diagonal supports to vertical supports with black coated 

screws, star washers, and black coated nuts. Hand tighten.

Attach bolt, lock washer, and nut to wheel shaft support. Use 

13mm socket wrench and box end wrench to fully tighten.

8

Attach tank retaining bracket to wheel shaft support. Align 

lower tab with slot. Tighten tank release knob halfway.

Use 10mm socket wrench and box end wrench to fully tighten 

all screws, star washers, and nuts.

Flip frame over. Check that frame is properly assembled. 

Temporarily place tank on frame. 

Important: Ensure cart is 

Lay cart back.