Emerson Series 3000 MVD Manuel D’Utilisation
Configuration and Use Manual
115
Configuring Custody Transfer
Co
nfi
guri
nfi
guri
ng Custod
y
T
ran
sf
sf
er
Star
tup
Con
fig
urin
g Tic
kets
Con
fig
ur
in
in
g Di
gi
tal
Co
mm
Co
mm
u
n
ic
a
tio
ns
14.7
Installing the weights and measures seal
The weights and measures seal must be installed and secured by a weights and measures inspector or
authorized third party.
authorized third party.
•
On a panel-mount Model 3300 or Model 3500, the inspector runs the wire seal through the
custody transfer tab, as shown in Figure 14-3.
custody transfer tab, as shown in Figure 14-3.
•
On a rack-mount Model 3300 or Model 3500, two locations are provided for the weights and
measures seal:
measures seal:
-
Required: The inspector must run a wire seal through the custody transfer tab, as shown in
Figure 14-4.
Figure 14-4.
-
Optional: The inspector may run a wire seal through the holes in the lockout screws on the
front panel of the platform, as shown in Figure 14-5.
front panel of the platform, as shown in Figure 14-5.
•
On a field-mount Model 3350 or Model 3700, a hasp on the housing is located beside the
circuit board compartment cover. The cover has four tabs. The inspector runs the wire seal
through the hole in the hasp and the hole in the nearest tab, as shown in Figure 14-6.
circuit board compartment cover. The cover has four tabs. The inspector runs the wire seal
through the hole in the hasp and the hole in the nearest tab, as shown in Figure 14-6.