Emerson Model 1700 Manuel D’Utilisation

Smart Meter Verification has an output mode called Continuous Measurement that allows the
transmitter to keep measuring while the test is in progress. If you choose to run the test in
Last Measured Value

 or Fault modes instead, the transmitter outputs will be held constant for

the two minute duration of the test. If control loops depend on transmitter outputs, take
appropriate action.

Avoid process instability during the test. If conditions are too unstable, the Smart Meter
Verification test will abort. To maximize process stability:

•

Maintain a constant fluid pressure and temperature.

•

Avoid changes to fluid composition, e.g., two-phase flow or settling.

•

Maintain a constant flow rate.

Tips
•

The Smart Meter Verification test runs best when flow is stopped through the sensor.

•

Smart Meter Verification is not affected by any configured transmitter parameters for flow,
density, or temperature.

9.2.3

Run Smart Meter Verification

1.

Navigate to the Smart Meter Verification menu.

Scroll and Select simultaneously 

for 4 seconds

Scroll

Select

Scroll

Scroll

Scroll

Scroll

Select

Select

Select

Select

2.

Choose Run Verfy.

3.

Choose Outputs and select the desired output behavior.

Continue
Measr

During the test, all outputs will continue to report their assigned process var-
iable. The test will run for approximately 90 seconds.

Fault

During the test, all outputs will report the last measured value of their as-
signed process variable. The test will run for approximately 140 seconds.

Measurement support

135