Emerson Model 1700 Manuel D’Utilisation

1.

Plug the terminal blocks into the terminal board.

2.

Replace the end-cap on the core processor housing.

3.

Replace the lid on the sensor junction box.

When reassembling the meter components, be sure to grease all O-rings.

The core processor has an LED that indicates different meter conditions.
1.

Maintain power to the transmitter.

2.

If you have a 4-wire remote installation or a remote core processor with remote
transmitter installation:

a. Remove the core processor lid. The core processor is intrinsically safe and can be

opened in all environments.

b. Check the state of the core processor LED.

3.

If you have an integral installation:

a. Loosen the four cap screws that fasten the transmitter to the base.

Base

4 x cap screws (4 mm)

Transition ring

Transmitter

Core processor

b. Rotate the transmitter counter-clockwise so that the cap screws are in the

unlocked position.

c. Gently lift the transmitter straight up, disengaging it from the cap screws.

Do not disconnect or damage the wires that connect the transmitter to the core
processor.

d. Check the state of the core processor LED.

Troubleshooting

212