Emerson Model 1700 Manuel D’Utilisation

Base

4 x cap screws (4 mm)

Transition ring

Transmitter

Core processor

b. Rotate the transmitter counter-clockwise so that the cap screws are in the

unlocked position.

c. Gently lift the transmitter straight up, disengaging it from the cap screws.

4.

If you have a 9-wire remote installation:

a. Remove the end-cap.

Transmitter

Core processor

4 x cap screws (4 mm)

End-cap

b. Inside the core processor housing, loosen the three screws that hold the core

processor mounting plate in place.

Do not remove the screws.

c. Rotate the mounting plate so that the screws are in the unlocked position.
d. Holding the tab on the mounting plate, slowly lower the mounting plate so that

the top of the core processor is visible.

Troubleshooting

216