Emerson Model 1700 Manuel D’Utilisation
Need help?
If an error message appears:
•
Verify the Modbus address of the transmitter.
•
Ensure that you have specified the correct COM port.
•
Check the physical connection between the PC and the transmitter.
•
Increase or decrease resistance.
•
For long-distance communication, or if noise from an external source interferes with the
signal, install 120-
signal, install 120-
Ω ½-W terminating resistors in parallel with the output at both ends of
the communication segment.
•
Ensure that there is no concurrent Modbus communication to the transmitter.
C.3
Menu maps for ProLink II
Main menu
Figure C-9:
File
Preferences
• Use External Temperature
• Enable Inventory Totals Reset
• Enable External Pressure Compensation
• Copper RTD
• Use External Temperature
• Enable Inventory Totals Reset
• Enable External Pressure Compensation
• Copper RTD
Installed options
Load from Xmtr to File
Save to Xmtr from File
Save to Xmtr from File
License
Connect to Device
Connect to Densitometer/
Viscometer
Disconnect
Connect to Densitometer/
Viscometer
Disconnect
View
Connection
Additional configuration options
Using ProLink II with the transmitter
Configuration and Use Manual
273