Emerson 1700 Manuel D’Utilisation

22

If you chose a 9-wire remote installation (see Figure 2-1), a 9-wire cable must be used to connect the 
junction box on the sensor to the core processor on the transmitter/core processor assembly. 

To connect the cable, follow the steps below:

1. Refer to Micro Motion’s 9-Wire Flowmeter Cable Preparation and Installation Guide for 

instructions on cable shielding and preparation:

•

At the sensor end, follow the instructions for your cable type.

•

At the transmitter end, follow the instructions for your cable type with an MVD 
transmitter.

2. To connect the wires, refer to Micro Motion’s 9-Wire Flowmeter Cable Preparation and 

Installation Guide and follow the instructions for your sensor with an MVD transmitter. 
Additional information for connecting the wires at the transmitter is provided below:

a.

Identify the components shown in Figure 2-6.

b.

Remove the end-cap.

c.

Insert the 9-wire cable through the conduit opening.

d. Connect the wires to the plugs supplied with the transmitter. 

e.

Insert the plugs into the sockets inside the lower conduit ring. See Figure 3-4.

3. Ground the cable. 

Do not allow the shield drain wires to contact the sensor junction box.

Brown
Red

Green
White

Blue
Gray

Orange
Violet
Yellow

Black
(Drains from all
wire sets)

Plug and

socket

Mounting screw

Blue
Gray
Orange

Red
Green
White

Brown

Violet

Yellow

Ground screw

Black