Emerson IFT9701 Manuel D’Utilisation

10

 continued

To re-install the cover of the circuit board compartment:

1. Screw the cover back onto the housing.

2. Hand-tighten the cover until it seats on the O-ring.

3. If the circuit board compartment has a lockout device, as shown in Figure 2-2, rotate the clamp 

into place and push it into the slot. Use a 4-mm (5/32-inch) Allen wrench to tighten the lockout 
screw to 5 inch-pounds (0,56 N-m) of torque.