Dyson DCO1 Manuel D’Utilisation

Undo three cross-head screws.

Remove soleplate by lifting from the back, and then
remove brush bar.

If cradle becomes detached from soleplate, align
circular ends of cradle with corresponding holes of
soleplate and slot into place, ensuring that ‘front’
edge of cradle faces the right direction.

After unplugging the cleaner, carefully remove any
entwined cotton, wool or fluff with scissors. 

NOTE: Failure to remove these may result in loss of
performance and possible damage to the machine.

Fit belt over motor
shaft and domed
section of brush bar.

Pull belt taut and
locate brush bar 
in slot.

D Y S O N C U S T O M E R C A R E

T E T B U R Y

H I L L

M A L M E S B U R Y

W I L T S H I R E

E N G L A N D

S N 1 6

O R P

With raised section
on end of brush bar
orientated as
shown, locate brush
bar in slot and
rotate end cap
towards back of
machine until it
comes to a stop.

End cap of brush bar

Raised section

Cradle

Soleplate