Honeywell TH6110D Manuel D’Utilisation

Page de 16
FocusPRO
TH6110D Programmable Thermostat
1
Product Application
This thermostat provides electronic control of 24 VAC single-stage heating and cool-
ing systems, or 750 mV heating systems.
System Types
Gas, oil, or electric heat with air
conditioning
Warm air, hot water, high-efficiency
furnaces, heat pumps, steam, gravi-
ty
Heat only — two-wire systems,
power to open and close zone
valves (Series 20), and normally-
open zone valves
Heat only with fan
Cool only
750 mV heating systems
Power Options
Battery power only
Common wire only
Common wire with battery backup
Changeover Options
Selectable manual or 
auto-changeover modes
System Settings
Heat, Off, Cool,Auto
Fan Settings
Auto, On
Must be installed by a trained, experienced technician
Read these instructions carefully. Failure to follow these instructions can dam-
age the product or cause a hazardous condition.
Check the ratings in this booklet to verify that this product is suitable for your
application (see page 13).
Always test for proper operation after installation (see page 9).
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before 
beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not
place the old control in the trash. Contact your local waste management authority for
instructions regarding recycling and proper disposal.
Install the thermostat about 5 feet (1.5m) above the floor in an area
with good air circulation at average temperature.
Do not install in locations where the thermostat can be affected by:
• Drafts or dead spots behind doors and in corners
• Hot or cold air from ducts
• Sunlight or radiant heat from appliances
• Concealed pipes or chimneys
• Unheated/uncooled areas such as an outside wall behind the thermostat
NO
NO
NO
® U.S. Registered Trademark. Patents pending. 
Copyright © 2005 Honeywell International Inc. All rights reserved.
IIn
nsstta
alllla
attiio
on
n
Pre-installation checklist ................2
Wallplate installation ......................3
Wiring..............................................4
Wiring diagrams ..............................5
Power options ................................7
Thermostat mounting ....................7
S
Se
ettu
up
p  a
an
nd
d  tte
essttiin
ng
g
Installer setup..................................8
Installer system test ........................9
Explanation of features ................10
A
Ap
pp
pe
en
nd
diic
ce
ess
Quick reference to controls..........11
Quick reference to display............11
Battery replacement......................11
In case of difficulty ......................12
Accessories/replacement parts ....13
Specifications ................................13
Table of contents
Installation tips