Honeywell 96D Manuel D’Utilisation
16
96d User Manual
M-511401
Honeywell
8/10
Introduction
Relay Output
Relay Output
Jumper Use Instructions
The jumpers on the controller PCB allow a variety of operations to be
performed manually:
performed manually:
EOL 1-4: Enables the user to add End-Of-Line jumpers that improve
communication signals. Put the jumper in R position (as
shown on wiring diagram) to activate the End-of-Line
termination. (R provides a resistance termination and RC
provides resistance and condensator termination.)
shown on wiring diagram) to activate the End-of-Line
termination. (R provides a resistance termination and RC
provides resistance and condensator termination.)
SHDN:
Enables the microcontroller to be reset or temporarily shut
down. This function is used mainly when system wiring
adjustments are needed (power off for safety).
down. This function is used mainly when system wiring
adjustments are needed (power off for safety).
Relays
These jumpers allow the relay to be tested by activating it
J29-J32 without having any effect on Events.