Empire Comfort Systems DVP48FP9 Manuel D’Utilisation

Page 32

17375-6-0705

STANDING PILOT LIGHTING INSTRUCTIONS

4.   Push in gas control knob slightly and turn clockwise 

 to "OFF." Do not force.

5.  Close bottom louver assembly.

  9.   Push in control knob all the way and hold in. Repeatedly 

push the piezo ignitor button until the pilot is lit. Continue 

to hold the control knob in the for about one (1) minute 

after the pilot is lit. Release knob, and it will pop back 

up. Pilot should remain lit. If it goes out, repeat steps 5 

through 9.

 •  If  the  control  knob  does  not  pop  up  when 

released,  STOP  and  IMMEDIATELY  call  a 

qualified service technician or gas supplier. 

 •  If the pilot will not stay lit after several tries, 

turn the gas control knob to "OFF" and call 

your service technician or gas supplier. 

  10.  Turn gas control knob counterclockwise 

  to 

"ON." 

  11.   Close bottom louver assembly.

  12.  Turn  on  all  electric  power  to  the  appliance  (if 

applicable).

  13.  Set REMOTE/OFF/ON switch to desired setting. 

  1.   Stop! Read the safety information above.

  2.  Set REMOTE/OFF/ON switch to OFF.

  3.  Turn  off  all  electric  power  to  the  appliance  (if 

applicable).

  4.  Lower bottom louver assembly.

  5.  Push in gas control knob slightly and turn clockwise 

 

to "OFF."

 

Note: Knob cannot be turned from "PILOT" to "OFF" unless 

knob is pushed in slightly. Do not force.

  6.   Wait ten (10) minutes to clear out any gas. Then smell for 

gas, including near the floor. If you then smell gas, STOP! 

Follow "B" in the safety information above. If you do not 

smell gas, go to the next step.

  7.  Find pilot - Follow metal 

tube from gas control. The pilot is 

behind the burner on the right side.

  8.  Turn gas control knob 

counterclockwise

 to 

"PILOT."

TO TURN OFF GAS TO FIREPLACE

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, 
personal injury or loss of life.

A.   This appliance has a pilot which must be lighted by hand. 

When lighting the pilot, follow these instructions exactly.

B.   Before  lighting  smell  all  around  the  appliance  area  for 

gas. Be sure to smell next to the floor because some gas is 

heavier than air and will settle on the floor.

 

What To Do If You Smell Gas

• Do not try to light any appliance.

• Do not touch any electrical switch; 

  do not use any phone in your building.

• Immediately call your gas supplier from a neighbor's 

phone. Follow the gas supplier's instructions.

• If you cannot reach your gas supplier, call the fire 

department.

C.   Use only your hand to push in or turn the gas control 

knob. Never use tools. If the knob will not push in or 

turn by hand, don't try to repair it; call a qualified service 

technician. Force or attempted repair may result in a fire 

or explosion.

D.   Do not use this appliance if any part has been under 

water. Immediately call a qualified service technician 

to inspect the appliance and to replace any part of the 

control system and any gas control which has been under 

water.

LIGHTING INSTRUCTIONS

1.   Set REMOTE/OFF/ON switch to OFF.

2.   Turn off all electric power to the appliance if service is to 

be performed (if applicable).

3.   Lower bottom louver assembly.

THERMOCOUPLE

ELECTRODE

PILOT

THERMOPILE

GAS CONTROL KNOB SHOWN

IN "OFF" POSITION

REMOTE

OFF

ON