Emerson 308014EN Manuel D’Utilisation
7-7
Rosemount Tank Radar REX
Chapter 7 Bus Modems
Installation Manual
308014EN, Edition 4
May 2013
May 2013
7.1.7
Operation
Front Panel
The FBM 2180 front LEDs show information on power supply,
communication status and communication interface.
communication status and communication interface.
Figure 7-7.
FBM 2180 front panel
The Termination switch is used if there are extremely short cables
between the transmitter and the modem.
between the transmitter and the modem.
The Gain switch is set to Lo by default. This setting is sufficient in most
cases. The Hi Gain setting may be used if cable dimensions are
insufficient resulting in a heavily damped communication signal.
cases. The Hi Gain setting may be used if cable dimensions are
insufficient resulting in a heavily damped communication signal.
7.1.8
Communicating with TankMaster™
TankMaster WinSetup allows you to setup the communication between a
PC, Field Communication Unit (FCU) and field instruments in a
Rosemount Tank Gauging system. For each communication port that is
used on the PC a protocol channel has to be configured (see the
TankMaster WinSetup Reference Manual for more information on
communication protocol setup).
PC, Field Communication Unit (FCU) and field instruments in a
Rosemount Tank Gauging system. For each communication port that is
used on the PC a protocol channel has to be configured (see the
TankMaster WinSetup Reference Manual for more information on
communication protocol setup).
LEDs for external power
and communication
Gain
switch
Termination
switch
External power
RS232
USB
Receive
Transmit
FBM2180_Front.eps