Emerson 308014EN Manuel D’Utilisation
Rosemount Tank Radar REX
Chapter 7 Bus Modems
Chapter 7 Bus Modems
7-12
Installation Manual
308014EN, Edition 4
May 2013
Below follows a short configuration description. Details are described in
the Enraf Emulation Guideline (reference number 308013EN) and in
TankMaster WinSetup Reference Manual (reference number
303027EN).
the Enraf Emulation Guideline (reference number 308013EN) and in
TankMaster WinSetup Reference Manual (reference number
303027EN).
Step 1
Connect the EBM.
Step 2
Configure the gauge in WinSetup.
Step 3
Install a tank in Winsetup: Required only for Hybrid / LPG systems
for which the analog inputs are used. However it is a good idea to
install a tank and associate a gauge to it, because then it is possi-
ble to benefit from the Open Tank View function.
for which the analog inputs are used. However it is a good idea to
install a tank and associate a gauge to it, because then it is possi-
ble to benefit from the Open Tank View function.
Step 4
Configure the gauge by using the Hybrid Calculation window
(Hybrid
system) or LPG Setup window (LPG system) in Winsetup.
(Hybrid
system) or LPG Setup window (LPG system) in Winsetup.
Step 5
Set holding registers for free water level measurements.
Step 6
Enter information into the Enraf Emulation window in WinSetup.
Set Enraf mode and move EBM switch from Modbus to Normal
(Enraf).
Set Enraf mode and move EBM switch from Modbus to Normal
(Enraf).
Step 7
Close Enraf Emulation window. The gauge now acts like an Enraf
instrument and the EBM can be disconnected. Connect the field-
bus to the CIU.
instrument and the EBM can be disconnected. Connect the field-
bus to the CIU.