Elite Video vsx33 Manuel D’Utilisation

En

If you have a tripod, use it to place the microphone so that 
it’s about ear level at your normal listening position. If you 
do not have a tripod, use some other object to install the 
microphone.

1

The Full Auto MCACC display appears once the 
microphone is connected.

2

If the speakers are connected using any setup other than 
Normal(SB/FH), be sure to set Speaker System before 
the Auto MCACC Setup. See Speaker system setting on 
page 83.

• Speaker System

4

 – Shows the current settings. 

When this is selected and ENTER is pressed, the 
speaker system selection screen appears. Select the 
proper speaker system, then press RETURN to return.

• EQ Type – This determines how the frequency 

balance is adjusted.

• MCACC – The six MCACC presets are used for storing 

surround sound settings for different listening 
positions. Simply choose an unused preset for now 
(you can rename it later in Data Management on 
page 80).

• THX Speaker – Select YES if you are using THX 

speakers (set all speakers to SMALL), otherwise leave 
it set to NO.

Make sure the microphone is connected, and if you’re 
using a subwoofer, make sure it is switched on and set to 
a comfortable volume level.

speaker configuration in the GUI screen.
A progress report is displayed on-screen while the 
receiver outputs test tones to determine the speakers 
present in your setup. Try to be as quiet as possible while 
it’s doing this.

If no operations are performed for 10 seconds while the 
speaker configuration check screen is being displayed, 
the Auto MCACC Setup will resume automatically. In this 
case, you don’t need to select ‘OK’ and press ENTER in 
step 7.

• With  error messages (such as Too much ambient 

noise! or Check microphone.), select RETRY after 
checking for ambient noise (see Problems when 
using the Auto MCACC Setup on page 39) and 
verifying the mic connection. If there doesn’t seem to 
be a problem, you can simply select GO NEXT and 
continue.

 

The configuration shown on-screen should reflect the 
actual speakers you have.

• If you see an ERR message (or the speaker 

configuration displayed isn’t correct), there may be a 
problem with the speaker connection.
If selecting RETRY doesn’t work, turn off the power 
and check the speaker connections. If there doesn’t 
seem to be a problem, you can simply use 

/ to 

select the speaker and 

/ to change the setting 

and continue.

1 Install the microphone on a stable floor. Placing the microphone on any of the following surfaces may make accurate measurement 

impossible:
• Sofas or other soft surfaces.
• High places such as tabletops and sofa tops.

2 If you leave the GUI screen for over five minutes, the screen saver will appear.
3 •  When  data  measurement is taken, the reverb characteristics data (both before- and after-calibration) that this receiver had been storing will 

be overwritten. If you want to save the reverb characteristics data before measuring, connect a USB memory device to this receiver and 
transfer the data.
• When measurement is taken of the reverb characteristics data other than SYMMETRY, the data are not measured after the correction. If 
you will need to measure after correcting data, take the measurement using the EQ Professional menu in the Manual MCACC setup (page 75).

4 If you are planning on bi-amping your front speakers, or setting up a separate speaker system in another room, read through Speaker system 

setting on page 83 and make sure to connect your speakers as necessary before continuing to step 4.

VSX-33_UXJCB.book  38 ページ  ２０１０年３月９日　火曜日　午前１０時３９分