Multiquip QP-202TH Manuel D’Utilisation

6. Grasp the starter grip (Figure 11) and slowly pull it out. The

resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.

7. If the engine has started, slowly return the choke lever

(Figure 12 ) to the 

CLOSED position. If the engine has not

started repeat steps 1 through 6.

8. Before the pump is placed into operation, run the engine for

several minutes.  Check for  fuel leaks, and noises that would
associate with a lose component.

9.

To begin pumping, place the throttle lever (Figure 13) in the
"

RUN"position.

1. Move the throttle lever  to the  IDLE position  (Figure 14) and

run the engine for three minutes at low speed.

2. After the engine 

cools, turn the engine ON/OFF switch to the

“OFF” position (Figure 15).

3. Place the 

fuel shut-off  lever  (Figure 16)  in the OFF

position.

1. Move the throttle lever quickly to the 

IDLE  position, and place

the engine ON/OFF switch in the 

OFF position.

ALWAYS  run engine at 

full speed while

pumping.