GE C11 Manuel D’Utilisation
-73-
8-3
Electrical measurements in the Main Circuit
The indicated values depend on the meter types because of harmonic components included in the voltage and
current of the main power supply (input) and the output (motor) side of the drive. Therefore, when measuring
with a meter for the commercial power frequency, use the meters shown in Table 8-3-1.
current of the main power supply (input) and the output (motor) side of the drive. Therefore, when measuring
with a meter for the commercial power frequency, use the meters shown in Table 8-3-1.
The power-factor cannot be measured using the power-factor meter available on the market which measures the
phase difference between voltage and current. When the power-factor must be measured, measure the power,
voltage, and current on the input side and output side. Then, calc ulate the power-factor using the following formu-
las:
Three-phase
Single -phase
phase difference between voltage and current. When the power-factor must be measured, measure the power,
voltage, and current on the input side and output side. Then, calc ulate the power-factor using the following formu-
las:
Three-phase
Single -phase
Table 8-3-1 Meter for measuring the main circuit
(*1) When measuring the output voltage by rectifier type meter, an error may occur. Use a digital AC power meter
for good accuracy.
for good accuracy.
Power factor =
Electric power [W]
3
x Voltage [V] x Current [A]
x 100 [%]
Electric power [W]
Voltage [V] x Current [A]
x 100 [%]
Power factor =
Moving-coil
type
Moving-
iron type
iron type
Rectifier
type
type
(*1)
Power me-
ter
ter
Power me-
ter
ter
Rectifier or
moving-iron
type
moving-iron
type
Moving-
iron type
iron type
DC voltme-
ter
ter
V
Wattmeter
Wattmeter
Voltmeter
Voltmeter
Ammeter
Ammeter
Ammeter
Symbol
Meter
type
type
Meter
name
name
Terminal
section
section
DC circuit
Current
waveform
waveform
Current
waveform
waveform
Voltage
waveform
waveform
Output (motor) side
Input (power supply) side
Item
-
-
Voltage
waveform
waveform