3M G5 Manuel D’Utilisation
Appendix: Greeter Module
November 6 2014 – Revision 2.1
Page 64 of 77
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
h)
Message Names
Message Activation
Perform the following procedure to schedule and activate GREETER and
REMINDER messages.
REMINDER messages.
Note:
This step should be done after Daypart Definitions have been configured and
Messages Recorded.
Messages Recorded.
1.
Enter the greeter configuration menu.
2.
Select
1 Message Activation
.
Act.<NO > :MESSAGE ACTIVATION:
Msg.<001><MON> [Breakfast 1 ][GREETER]
[ Breakfast ]<NO >
Msg.<001><MON> [Breakfast 1 ][GREETER]
[ Breakfast ]<NO >
▐
[ Morning ]<NO >
[ Lunch ]<NO >
▐
[ Afternoon ]<NO >
3.
Using the , , ⊳, and
Enter
keys, select a message number and
day of the week to configure.
Msg.<001><MON>
4.
For the selected message, set the value to “YES” for each daypart the
message is active,
message is active,
[ Breakfast ] <YES>
, leaving the other
dayparts set to
[ Morning ] <NO >
5.
Repeat the daypart assignments for each day of the week.
Msg.<001><TUE>
6.
When done, activate the message schedule by selecting “YES”.
Act.<YES>
7.
Repeat steps 3 – 6 for each message you wish to schedule and activate.
Record Message
After determining the number and type of messages to use in the drive-thru
operation, the user will then record each message into the Greeter Module
memory.
operation, the user will then record each message into the Greeter Module
memory.
Perform the following procedure to record and playback messages:
1.
Enter the greeter configuration menu.
2.
Select
2 Record Messages
.
:RECORD MESSAGES:
Msg.<001> Type:<GREETER > [REC.] [PLAY]
Duration:<00> Time:[
Msg.<001> Type:<GREETER > [REC.] [PLAY]
Duration:<00> Time:[
]
Name:<Breakfast 1 > {Mode=Exit}
Note:
If you store a new message in an occupied slot, the old greeter message will
be permanently erased.
If you store a new message in an occupied slot, the old greeter message will
be permanently erased.
Each recorded message can be no more than 8 seconds long (GREETER,
CLOSED, FORWARD) or 4 seconds long (REMINDER, ALERT)
CLOSED, FORWARD) or 4 seconds long (REMINDER, ALERT)
3.
Put on a working headset with the power on.
4.
Using the , , ⊳, and
Enter
keys, select a message number to
record.
Msg.<001>
.