CSR v3.2 Manuel D’Utilisation

 

 

 
 
 

Pairing 

 

blab-ug-005Pa 

© Cambridge Silicon Radio Limited 2005 

This material is subject to CSR’s non-disclosure agreement. 

Page 16 of 24

 

 

The Combined AV Headset Application is now running on the BlueCore3-Multimedia Demonstration Board. To 
stream audio and connect a mobile telephone to the headset, it needs to be paired.  

Stop the application by pressing 

. This stops the application debugger and halts operation. 

To make the headset discoverable for 60 seconds, hold down 

 and 

 and press the 

 button. The 

blue LED will begin flashing more rapidly indicating the device is discoverable. In this state the headset can be 
discovered by AV sources or a Bluetooth-enabled handset that supports the Headset or Handsfree profile. 

With the Combined AV Headset in discoverable mode, pair the handset with the headset. The Pin Code is 8888. 
Refer to the Instruction Manual supplied by the Handset manufacturer for further information on pairing. 

The USB Multimedia dongle is supplied as part of the BlueLab3-Multimedia Development Kit. Plug this dongle 
into the USB port of your PC and start the 

avcontrol.exe

 application located in the following folder: 

\BlueLab\tools\bin\ 

With the Combined AV Headset in discoverable mode, click on the 

 button. The 

Multimedia dongle will locate the headset, pair and connect to the headset. 

Note:   By default a device running the

 av_headset_hfp

 application has a PIN of 8888. However, Multimedia 

dongles shipping with previous versions of BlueLab have a PIN of 4444. 
 
If the devices fail to connect it is probable because the PINs are not matched. 
 
The way to resolve this conflict is to change the entry in the  

av_headset_hfp.psr

 file  that sets the 

PSKEY_FIXED_PIN

. Change  &035b = 0038 0038 0038 0038  to &035b = 0034 0034 0034 0034. When the 

application is run in xIDE the PIN will then be set to 4444.