Plantronics W430 Manuel D’Utilisation

Plantronics Savi User Guide

10

The headset and USB adapter that are supplied are subscribed 
to each other. However, if you wish to use a new master headset 
with your existing USB adapter, the units can be subscribed to 
each other by the following method:

  Ensure your replacement headset is charged.

  Double press the subscription button on the USB adapter. The 

USB adapter will flash red and green.

  Press the volume up button on the headset for three seconds 

until the headset indicator light turns solid green.

  When the indicator light on the USB adapter goes solid green, 

the headset and the USB adapter are subscribed to one 
another. 

 If the subscription process times out after two minutes or if 

the subscription process fails, the USB adapter indicator light will 
become solid red for four seconds and then return to its previous 
state. If this occurs, try to re-subscribe the headset again.

While on a call, you can subscribe up to three additional headsets 
to your USB adapter for conferencing. As you add headsets 
to the adapter, an additional headset icon will appear in the 
Plantronics software screen with a number from 1 to 3 indicating 
the number of additional headsets subscribed to the adapter.  

Guests may conference in as described below: 

  While you are on a call, place the guest’s headset into 

subscription mode by pushing the headset volume up button 
for three seconds until the headset indicator light becomes 
solid green.

  Short press (less than one second) the subscription button on 

the USB adapter. The USB adapter light will flash yellow and 
green.

  The USB adapter light will then turn solid yellow and you will 

hear a tone in the master headset indicating a guest wishes to 
join the call.

  If you press the call control button on the master headset 

within five seconds, the guest is joined to the call. 

  If you do not press the call control button within five seconds, 

the request to join the call is rejected and the guest will hear an 
error tone in their headset.

  Guests may leave the conference call by pressing their call 

control button. 

  When they do you will hear a single tone in the master headset 

as each guest leaves the call.

To see how many headsets are subscribed to the adapter, refer 
to the lower left-hand corner of the Plantronics Control Panel 
software screen. The first headset is the master headset and the 
number inside the next headset is the number of guest headsets 
subscribed to the adapter. The examples below show 1, then 2, 
then 3 guest headsets subscribed to the adapter in addition to 
the master headset. 

1

2

3

The Savi W430 is supplied with narrowband audio as the default. 
You can toggle between narrowband and wideband audio by 
doing a short press (less than one second) followed by a long 
press (more than three seconds) on the USB adapter subscription 
button while it is in an idle state. The USB adapter light will flash 
red for four seconds upon entering narrowband mode and flash 
green for four seconds upon entering wideband mode. 

The Savi W430 is supplied with high range set as the default. 
You can change the range setting by holding in the subscription 
button of the USB adapter for three seconds while it is in an idle 
state. The USB adapter light will flash green for high range, yellow 
for medium range and red for low range.

If the USB adapter is in subscription mode and you want to stop 
the adapter from searching for a headset, press the subscription 
button again. The subscription light will turn solid red for four 
seconds and then go to its previous state. 

If you won’t be using the headset for a long period of time and 
the headset will not be in the charging cradle, you can put the 
headset in sleep mode by pressing the call control button for 
three seconds while in an idle state. To exit sleep mode, press the 
headset call control button again for three seconds.