iHome ib22 Fascicule

Model: iB22 (Back) 

Print color : Black text on white paper

Size of manual: 100mmW x 180mmH

Date: Dec 6, 2012

iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI 

Technologies), warrants this product to be free from defects in workmanship and 

materials, under normal use and conditions, for the lifetime of the product from 

the date of original purchase.

Should this product fail to function in a satisfactory manner, it is best to first return 

it to the store where it was originally purchased. Should this fail to resolve the 

matter and service still be required by reason of any defect or malfunction during 

the warranty period, SDI Technologies will repair or, at its discretion, replace this 

product without charge (except for a $2.00 charge for handling, packing, return 

UPS/postage, and insurance). This decision is subject to verification of the defect 

or malfunction upon delivery of this product to the Factory Service Center listed 

below. The product must include proof of purchase, including date of purchase. 

The fee for service without proof of purchase is $4.00.

Before returning this product for service, please first replace the batteries (if 

applicable) with fresh ones, as exhausted or defective batteries are the most 

common cause of problems encountered.

If service is still required:

1. Remove the batteries (if applicable) and pack the unit in a well padded, heavy 

corrugated box.

2. Enclose a photocopy of your sales receipt, credit card statement, or other 

proof of the date of purchase, if within the warranty period.

3. Enclose a check or money order payable to the order of SDI Technologies, 

for the sum of $2.00 ($4.00 without proof of purchase).

4. Send the unit prepaid and insured, to the Factory Service Center listed below.

SDI Technologies Inc.

1330 Goodyear Drive

El Paso, TX 79936-6420

Disclaimer of Warranty

NOTE: This warranty is valid only if the product is used for the purpose for which 

it was designed. It does not cover (i) products which have been damaged by 

negligence or willful actions, misuse or accident, or which have been modified 

or repaired by unauthorized persons; (ii) cracked or broken cabinets, or units 

damaged by excessive heat; (iii) damage to digital media players, CD’s or tape 

cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service 

Center and its return to the owner.

This warranty is valid only in the United States of America and does not extend 

to owners of the product other than to the original purchaser. In no event will SDI 

Technologies or any of its affiliates, contractors, resellers, their officers, directors, 

shareholders, members or agents be liable to you or any third party for any 

consequential or incidental damages, any lost profits, actual, exemplary or punitive 

damages. (Some states do not allow limitations on implied warranties or exclusion 

of consequential damages, so these restrictions may not apply to you.) This 

warranty gives you specific legal rights, and you may also have other rights which 

vary from state to state.

Your acknowledgement and agreement to fully and completely abide by the above 

mentioned disclaimer of warranty is contractually binding to you upon your transfer 

of currency (money order, cashier's check, or credit card) for purchase of your 

SDI Technologies product.

© 2012 SDI Technologies, Inc. All rights reserved

iB22-120612-A                   Printed in China

Model: iB22 (Front) 

Print color : Black text on white paper

Size of manual: 100mmW x 180mmH

Date: Dec 6, 2012

The earpieces are marked “L” and “R”. Place the “L” earpiece in your left ear 

and the “R” earpiece in your right ear for proper fit and best sound. If the 

earpieces are inserted incorrectly they will not fit properly in your ears and the 

sound quality will not be satisfactory.
Connect the headphone plug to the headphone jack of your music player. Be 

sure that the plug is fully inserted into the jack. If the plug is not fully inserted 

you may only hear sound from one earpiece.
NOTE: Your headphones are supplied with three different size silicon tips 

(S-M-L) for maximum comfort and to seal out unwanted noise. The “M” 

(medium) size tips were installed at our factory. If you find that the installed 

tips are too small or too large for your ears, you may remove them and 

replace them with the larger or smaller size accessory tips. To replace the 

tips simply pull them off the earpieces. To install different size tips, push them 

on to the earpieces and make sure they are fully seated on each earpiece so 

that they do not come off when you remove the earpiece from your ear. If 

one of the tips remains in your ear when you remove the headphones, 

remove the tip carefully and avoid pushing it further into your ear canal. Seek 

medical assistance if one of the tips becomes lodged in your ear and you are 

unable to remove it.
IMPORTANT! Listening at high volume for long periods of time can result in 

long-term hearing damage. For your safety, do not use headphones if they 

would prevent you from hearing warning sounds, such as while driving a car 

or motorcycle, riding a bike, etc.
NOTE: In extremely cold or dry air conditions you may notice a slight ‘tingling’ 

feeling in your ears when using in-ear headphones. This is the result of the 

build-up of static electricity in your body. This is normal and not an indication 

of any problem with your headphones.

The hang tag at this top of the package also functions as a convenient cord 

management device. Pass the headphone plug through the opening in the 

hang tag as shown and then wind the headphone cord around the hang tag. 

This will keep your headphone cord tangle free and always ready to use.