Logic 3 INSTRUCTION MANUAL Manuel D’Utilisation

Thank you for purchasing the Logic3 Sound System for use with the PSP, the latest in 
our long and established range of  speakers. As with all Logic3 products, this has been 
built to the highest manufacturing standards, to bring you the very latest and advanced 
technology available.

The PSP Sound System offers a complete solution to listen, recharge. It produces hi-fi 
quality sound from the combination of a sub-woofer, dynamic tweeter speakers and 
a 3D surround sound processor. The compact portable unit measures only 280 x 105 
x 38mm and weighs only 550g. The Sound System can be powered by an AC Mains 
Adaptor (supplied) or 4xAA Batteries (Not Included). By using the line-in port, the 
Sound System can used whilst holding the PSP in your hands or be used in conjunc-
tion with a number of other portable audio devices such as MiniDisc, MP3 Players or 
Portable CD Players.

Please follow the steps on the quick start guide to set up the PSP535

1)  Remove the Clear Plastic Protective Cover, being careful to not damage the 

speakers or sub woofer

2)  Fold down the Sub woofer unit

3)  Insert the AC Adaptor (supplied) or 4 x AA Batteries (Ensure that the batteries are 

inserted as indicated inside the battery compartments on the rear of the Sound 

System, to avoid potential damage)

4)  Switch on your PSP, press the Power button on the Sound System and adjust the 

volume to desired level

5)  Insert PSP

6)  Replace the Clear Plastic Protective Cover on the rear of the PSP535 to act as a 

support for the PSP

7)  The PSP Sound System can also be used whilst the PSP is being used in your 

hands using the Line In Cable

ENGLISH

3

a. Push the button once to switch on the Sound System. The Blue LED’s will illuminate 

when the Sound System is turned on.

b. Push the button again to switch off the Sound System.
c.  If the unit is unused for about 2 minutes, then the Sound System will automatically 

turn off to preserve power.

a. Press the Up or Down Arrows to adjust the Sound System sound level.

a.  Push the 3D button to enrich the sound with a wider effect. The sound will appear to sur-

round you. (The Volume level may need to turned down to avoid sound distortion.)

b. Push the button again to return to the normal stereo sound effect.

To recharge the PSP ensure that Sound System is connected to the AC Adaptor the 
PSP will recharge automatically 

The Sound System also offers the facility to allow portable audio devices such as MP3, 
Mini-Disc and Portable CD Players to be connected for use as a speaker system. Con-
nect the 3.5mm Line In Cable to the Headphone socket on the device and connect the 
other end to the Line–In socket to the rear of Sound System.

Should you have any connection or setup problems with the  please contact our 
Technical Support Hotline on +44 (0)208 902 2211 – National call rates apply or E-mail 
support@logic3.com

Total continuous power: 

12W RMS (6W + 3Wx2)

Satellite speakers: 

3Watts/channel @ 6 ohms

 

@10% THD + N @20~20kHz

Subwoofer: 

6Watts 6 ohms

Frequency Response: 

100 Hz ~ 20 kHz

Signal to Noise Ratio: 

@ 1 kHz input > 60 dB

Speaker Drivers: 

Two 2” full range neodymium

 

Micro drivers + 3” speaker

ENGLISH

4