Tascam DA-45HR Manuel Du Propriétaire

4 - Advanced functions

TASCAM DA-45HR

You can start the tape’s program numbers from a
value different from

by turning the

DATA

dial.

The program number selected with the

DATA

dial

will flash (the flashing will continue for five
seconds).

Confirm the flashing program number with the

ENTER

key. If you press

ENTER

after the program

number has stopped flashing, renumbering will start
from 01.

The tape will rewind to the first START ID, and
rewrite the ID in the same location as previously, but
with the number selected above.

When this is done, the number at the right of the dis-
play will change to the number which is one greater
than the starting program number, and the tape will
move forward to the next START ID and renumber it
in the same way.

While a START ID is being rewritten, the word

RENUM

will flash in the display, and the

PLAY

and

RECORD

indicators will light.

If the current START ID already has a number, this
will be shown to the left of the

mark on the

display:

If the current START ID is unnumbered, this is repre-
sented by a pair of dashes in the

PNO

location on the

display.

All program titles are retained during the renumber-
ing process.

The renumbering process continues until the end of
the tape or an END ID is reached.

NOTE

Valid program numbers are from 01 to 99. If
the above procedure is used to select a pro-
gam number at the high end of the range, and
the renumbering increments a program num-
ber above 99, the number will “wrap” to 00.
The number 00 can cause problems when
searching and locating, and this should be
remembered when setting program numbers.

4.5 The EDIT key

The

EDIT

key (

SHIFT

MENU [28]

) allows the

following operations to the performed:

• Editing of the first memory location

• Editing of the second memory location

• Editing of a programmed sequence of programs for

subsequent playback

• Editing of a string of characters to be used as a tape

or program title

• Writing a string of characters to tape

Repeated presses of

EDIT

will cycle through these

options.

To exit the EDIT mode, press

COUNTER MODE

DISPLAY

(as with all

SHIFT

ed modes, pressing the

SHIFT

key so that the

SHIFT

indicator goes out will

exit the

SHIFT

mode).

The

ENTER

key is used to select the operation.

4.6 Location memories

4.6.1 Locating to location memories

Once a memory location has been set, as explained
below, use the

LOC 1

and

LOC 2

keys to locate to

the memory location points (as explained in

LOC 1

[29]

4.6.2 Setting location memories

Press the

MEMO 1

MEMO 2

key. The current

location will be stored to frame accuracy, regardless
of whether or not the frame display mode is currently
in operation, in memory location 1 or 2 as
appropriate.

4.6.3 Editing location memories

Press

EDIT

until the display shows either

M1?

M2?

at the right, together with the location value

stored in that location memory.

Press

ENTER

to start editing the location memory.

The word

Edit

will appear at the right of the dis-

play, and the right digit of the frames field will start
to flash.

Use the

SHUTTLE

wheel to move the cursor (flash-

ing digits) between the frames, seconds, minutes and
hours fields.

Use the

INS/+

and

DEL/-

keys and the

DATA

dial to

increment or decrement the flashing value field.

PNO