Tascam DA-45HR Manuel Du Propriétaire
1 - Introduction to the DA-45HR
8
TASCAM DA-45HR
the word clock master for a digital audio
setup, any word clock slaves should receive
setup, any word clock slaves should receive
the clock through the digital audio signal.
1.5.4 Making control connections
The optional RC-D45 remote control unit may be
connected to the
connected to the
REMOTE IN
jack, using the 5 m
(approximately 16 ft) cable of the RC-D45.
WARNING
Do not attempt to use the tape deck with any
remote control unit except one designed
remote control unit except one designed
especially for use with this tape deck.
The
CONTROL I/O
connector is for use with suit-
ably-equipped control units (see
CONTROL I/O
[36]
).
1.5.5 Power connections
Make sure that your AC voltage supply matches the
voltage requirements of the tape deck (as printed on
the rear panel).
voltage requirements of the tape deck (as printed on
the rear panel).
1.6 Block Diagram