Coway BA13-AR Manuel D’Utilisation

10

  remove the protective film from the operation part before using it.

  the bidet only works normally when water is supplied.

   check if water leaks from the main water supply valve or the connecting hose.  

You must insert the rubber packing between the T-shaped connection pipe and the

main water supply pipe.

  Clean the MESH filter on a regular basis (The cleaning interval may differ

depending on the water quility). If the MESH filter is contaminated by foreign

substances, the filter is blocked or non-filtered cleansing water may be ejected.

   when the bidet has not been used for a long time, clean the filter and clean each part 

of the bidet such as the air dryer outlet, the nozzle and the seat before use (see p.16).

  - If the seat sensor does not detect anyone sitting down or no panel or remote control button is

pressed for approximately 10 minutes, bidet eco mode is activated, the eco mode indicator 

is turned on, and the seat temperature is set to ‘l’ to reduce the power consumption of the 

product.

 - when sitting down on the seat or pressing a panel button, the power indicator is turned on, the eco 

mode indicator is turned off and the seat temperature returns to the last configured temperature.

 - Even if you sit down on the seat or press a panel button, the power indicator is not turned

on. this means that the power is turned off. in this case, press the power selection button to 

turn the power on before using it.

This product is for 120 V~ / 60 Hz only.  

make sure to connect the power plug to a grounded electrical outlet    

(120 V~ / 60 Hz) dedicated to the product.

  You can configure one of the special modes (eco mode, seat sensor lock mode,

silent mode) according to your preferences (see p.11).

   Plug the power cord into the electrical outlet. the bidet only works normally when 

the electricity is connected. 

1210964 BA13 사용설명서_수출영문_(09.03.23).indd   10

2009.3.24   10:13:11 AM