Hearth & Home Technologies MTVERNINSAE-MBK Manuel D’Utilisation

Page  20

7036-135E

September 1, 2008

R

1.  Secure the top panel to the panel sides with the 

screws provided. Figure 20.3.

2.  Assemble the trim with the (2) corner brackets 

provided. Figure 20.4.

3.  Remove the 2 cast sides and slide the assembled 

trim over the assembled panel set. 

4. Carefully 

s

lide panel and trim over the top of the insert 

into place matching the mounting holes on the panel 
with the mounting holes on the insert.  Secure with 
screws provided.  Figure 20.5.

Back of Top Panel

Back of Side Panel

Screws

Included in Panel & Trim Kit: (2) corner brackets and set 
screws; (1) trim set, 3 piece; (2) side panels; (1) top panel; 
(4) screws. 

Tools Needed: Powered Phillips head screw driver

Shown with trim installed on panel set

1. Screw panels

together

2. Bend tabs down

1. Screw panels

together

3. Install Cast Trim Header

2. Bend tabs

down

Included in Panel Kit:  (2) side panels, left and right; (1) 
panel top; (1) fastener package.

Included in Cast Trim Kit:  (2) cast trim legs, left and right; (1) 
cast trim header; (2) cast trim footers, left and right; (1) fastener 
package. 

Tools Needed: Powered Phillips head screw driver

1.  Remove contents from box being careful not to scratch or 

damage the cast trim pieces.

2.  Lay the panel set face down on protective covering to prevent 

scratching the painted surface.

3.  Secure the panel legs to top panel with the screws 

provided.

4.  Now bend the tabs down toward the backside of the panel 

set, 5 on top and 2 on each leg.  Leave the panel set face 
down.  Figure 20.1.

5.  Place the corresponding cast trim pieces ( 2 cast trim legs 

and 1 cast trim header) underneath the panel set, also face 
down.

6.  Place washer provided over tab and secure the trim and panel 

together with screw.  Continue for all tabs.

7.  Secure cast footers with screws. 

8.  Remove both left and right cast sides from insert.  See  Figure 

9.  Slide panel and trim over the top of the insert into place 

matching the mounting tabs on the panel with the slots on 
the insert.