ONKYO TX-8522 Manuel D’Utilisation
13
Connecting Your Speakers
—Continued
In this model, the factory default for speaker impedance is “8 ohms.” When you change the speaker impedance setting,
read “Speaker Connection Precautions” on page 12 carefully before performing the procedures below.
read “Speaker Connection Precautions” on page 12 carefully before performing the procedures below.
Note:
Be sure to minimize the volume level on the receiver
before configuring the speaker impedance.
before configuring the speaker impedance.
Configuring the Speaker Impedance (TX-8522 North American model only)
1
Turn on the power.
2
Press the SETUP button on the
remote controller.
remote controller.
The “Impedance: 8 ohms” indication
appears in the display.
appears in the display.
3
Change the impedance value to
“6 ohms” using the [
“6 ohms” using the [
]/[
]
buttons.
2, 4
1
3
SETUP
4
Press the SETUP button on the
remote controller to complete the
setting.
remote controller to complete the
setting.
When you restore the impedance
setting to 8 ohms, use the same
procedures above.
setting to 8 ohms, use the same
procedures above.
TX-85228222_En.book 13 ページ 2006年5月4日 木曜日 午前11時51分