ONKYO tx-sr444 Manuel D’Utilisation

z

 Operation: Use the remote controller of this unit to 

operate the menus shown on the TV screen. To display the 

guidance, you need to make HDMI connection between 

the unit and TV. Select the item with the cursor buttons of 

the remote controller and press ENTER to confirm your 

selection. To return to the previous screen, press RETURN.

1 

Connect the power cord to the outlet (). Press 

z ON/

STANDBY on the main unit or 

z RECEIVER on the remote 

controller to turn the unit on or to standby mode.

 

● When the unit is turned on, a large instantaneous 

current may flow affecting functionality of the computer 

and other devices. It is recommended to use a separate 

outlet from that for the computer or such other sensitive 

devices.

¼



Taiwanese models include removable power cords. Connect the power cord 

to AC INLET of the unit and then connect to the outlet. Always disconnect 

the outlet side first when disconnecting the power cord.

2 

The AccuEQ Room Calibration function, our proprietary 

technology, measures the test tone coming from each 

speaker with the supplied speaker setup microphone, 

setting of the number of speakers, volume level, each 

speaker's optimum crossover frequencies, and distance 

from the primary listening position, and also enables 

correction of distortion caused by the acoustic environment 

of the room.

 

● You cannot return to the previous screen during speaker 

setup, even if you press RETURN.

1�  Place the speaker setup microphone�
Before starting the procedure, refer to the figure and 

place the supplied speaker setup microphone at the 

measurement position .

Listening area

Measurement position with 

microphone

¼



Correct measurement will not be possible if the microphone is held 

by hand. Measurement is not possible if headphones are being used.

¼



The subwoofer sound may not be detected since it is extremely 

low frequencies. Set the subwoofer volume to around the half of its 

maximum volume and make its frequency to the maximum level.

¼



Measurement may be interrupted if there is ambient noise or radio 

frequency interference. Close the window and turn off the home 

appliance and fluorescent light.

SETUP MIC jack

Speaker 

setup 

microphone