ONKYO TX-SR603/603E Manuel D’Utilisation
38
Connecting the AV Receiver
—Continued
• Before connecting the power cord, connect all your
speakers and AV components.
• Turning on the AV receiver may cause a momentary
power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the AV receiver into a different circuit.
equipment on the same circuit. If this is a problem,
plug the AV receiver into a different circuit.
Notes:
• Pressing the remote controller’s [ON] button once will
turn on the AV receiver. Pressing it again will turn on
any components connected via
any components connected via
.
• When the AV receiver is on Standby, it will turn on
automatically when any one of its input selector but-
tons is pressed.
tons is pressed.
• Before disconnecting the power cord from the wall
outlet, set the AV receiver to Standby.
Turning On the AV Receiver
1
Plug the power cord into an AC
wall outlet.
wall outlet.
The STANDBY indicator will light up.
2
Press the [STANDBY/ON] button.
Alternatively, press the remote
controller’s [RECEIVER] button
followed by the [ON] button.
Alternatively, press the remote
controller’s [RECEIVER] button
followed by the [ON] button.
The AV receiver comes on, the display
lights up, and the STANDBY indicator
goes off.
lights up, and the STANDBY indicator
goes off.
To turn off the AV receiver, press the
[STANDBY/ON] button. The AV
receiver will enter Standby mode.
[STANDBY/ON] button. The AV
receiver will enter Standby mode.
STANDBY/ON
STANDBY
ON
To wall outlet
STANDBY indicator
STANDBY
STANDBY/ON
STANDBY
ON
Remote
controller