ONKYO TX-NR626 Manuel D’Utilisation

• If the “Front High” settings is set to “None” (

), 

this setting cannot be selected.

• If the “Powered Zone 2” setting is set to “Yes” and Zone 2 

is turned on, this setting cannot be selected.

■

`

Auto:

If the source signal contains a Dolby EX flag, the 
Dolby EX listening mode is used.

`

Manual:

You can select any available listening mode.

This setting determines how Dolby EX encoded 
signals are handled. This setting is unavailable if no 
surround back speakers are connected. This setting 
is effective with Dolby Digital, Dolby Digital Plus and 
Dolby TrueHD only.

• If the “Surround Back” setting is set to “None” 

(

), this setting cannot be selected.

• If the “Powered Zone 2” setting is set to “Yes” and Zone 2 

is turned on, this setting cannot be selected.

• If the “Front High” setting is enabled (

setting is fixed to “Manual”.

■

`

`

On 

This setting specifies whether or not to apply the Late 
Night processing on a Dolby TrueHD source.

• When this setting is set to “Off”, the Late Night function for 

Dolby TrueHD sources is automatically fixed to “Off”.

■

`

0 to 2 to 5

The DTS Neo:6 Music listening mode creates 6-
channel surround sound from 2-channel stereo 
sources. With this setting, you can specify by how 
much the front left and right channel output is 
attenuated in order to create the center channel. 
Changing the value from “0” to “5” will spread the 
sound of the center channel to left and right 
(outwards).

■

`

Wide:

Select if the listening angle is greater than 30 
degrees.

`

Narrow:

Select if the listening angle is less than 30 
degrees.

With this setting, you can optimize the Theater-
Dimensional listening mode by specifying the angle of 
the front left and right speakers relative to the 
listening position. Ideally, the front left and right 
speakers should be equidistant from the listening 
position and at an angle close to one of the two 
available settings.

• For best results, we recommend setting “

” to 20° 

and “Wide” to 40°.

Items can be set individually for each input selector.
Press the input selector buttons to select an input 
source.

The tone for each speaker is set automatically by 
Audyssey MultEQ

®

 Room Correction and Speaker 

Setup. To enable the following settings, you must first 
perform the Room Correction and Speaker Setup 
(

• These technologies cannot be used when a pair of 

headphones is connected.

■

`

Off 

`

Movie:

Select this setting for movie material.
The Audyssey indicator will light.

`

Music:

Select this setting for music material.
The Audyssey indicator will light.

• When “Audyssey Quick Start” has been used for 

measurement, “Audyssey” cannot be selected.

• Audyssey equalizing does not work with DSD sources.

Front left speaker

Front right speaker

Listening angle: 30°