ONKYO tx-nr545 Manuel D’Utilisation

Firmware Update

¼



When an error occurs, "*-** Error!" is displayed on the unit. 

("*" represents an alphanumeric character.) Check the 

following:
Error Code

Ethernet cable not found. Connect the Ethernet cable 

properly.

Internet connection error. Check the following:

–  Whether the router is turned on

–  Whether this unit and router are connected to the 

network

Try to disconnect and then connect again the power 

to the unit and router. This may solve the problem. If 

you are still unable to connect to the Internet, the DNS 

server or proxy server may be temporarily down. Check 

the service status with your ISP provider.

First disconnect then reconnect the AC power cord, and 

then retry from the beginning.

● Prepare a 64MB or larger USB storage device.

–  Media inserted in a USB card reader may not be 

used for this function.

–  USB storage devices with security function are not 

supported.

–  USB hubs and USB devices with hub function are not 

supported. Do not connect these devices to the unit.

● Delete any data stored on the USB storage device.

● Turn off the controller component (PC etc.) connected to 

the network.

● Stop any playing Internet radio, USB storage device, or 

server content.

● If the multi-zone function is active, press OFF on the 

main unit to turn it off.

● If "HDMI CEC (RIHD)" is set to "On", set it to "Off" 

(default value).

–  After pressing RECEIVER on the remote controller, 

press SETUP. Then, after selecting "6. Hardware" 

- "HDMI" and pressing ENTER, select "HDMI CEC 

(RIHD)" to select "Off".

¼

½

Some USB storage devices may take long to load, may not be loaded 

correctly, or may not be correctly fed depending on the device or their 

content.

¼

½

Onkyo will not be liable whatsoever for any loss or damage of data, or 

storage failure arising from the use of the USB storage device with this 

AV receiver. Thank you for your understanding.

¼

½

The description may differ from the on-screen display but that will not 

change the way to operate or the function.

¼



1.  Connect the USB storage device to your PC.
2.  Download the firmware file from the Onkyo website to 

your PC and unzip.

Firmware files are named in the following way:

 ONKAVR****_************.zip

Unzip the file on your PC. The number of unzipped files 

and folders varies depending on the model.

3.  Copy all unzipped files and folders to the root folder of 

the USB storage device.

● Make sure to copy the unzipped files.

4.  Connect the USB storage device to the USB port of the 

unit.

● If you connect a USB hard disk drive to the USB 

port of the unit, we recommend that you use its AC 

adapter to power it.

● If the USB storage device has been partitioned, each 

section will be treated as an independent device.

5.  After pressing RECEIVER on the remote controller, 

press SETUP.