ONKYO TX-NR801 Manuel D’Utilisation

26

The

 terminal on the TX-NR801/TX-NR801E is for 

connecting other Onkyo components equipped with the 
same

 terminal. When a component is connected to 

the

 terminal, it can be operated by the remote 

controller supplied with the TX-NR801/TX-NR801E. In 
addition, when you connect a component to the

 

terminal, you can also perform the system operations 
given below.

Power on/ready function
When the TX-NR801/TX-NR801E is in the standby 
state, if an

-connected component is turned on, the 

TX-NR801/TX-NR801E also turns on and the input 
source selected at the TX-NR801/TX-NR801E 
automatically switches to that component.
Be aware that this function will not work if the power 
cord for the

-connected component is connected to 

the AC OUTLET on the TX-NR801/TX-NR801E, or if 
the TX-NR801/TX-NR801E has already been turned on.

Direct change function
When the play button is pressed on an

-connected 

component, the input source selected at the TX-NR801/
TX-NR801E automatically changes to that component. 

Power off function
When the TX-NR801/TX-NR801E is placed in the 
standby state, all

-connected components are also 

automatically put into the standby state.
Also, if you press the ON button on the TX-NR801/
TX-NR801E remote controller while the TX-NR801/
TX-NR801E is turned on, all

-connected 

components (DVD players, CD players, MD recorders, 
tuners, etc.) are also turned on.

To connect components using the

 terminal, simply 

connect a remote control cable from this

 terminal to 

the

 terminal of the other component. An

 remote 

control cable with a 1/8 inch (3.5 mm) miniature two-
conductor plug comes with every cassette tape deck, 
compact disc player, MD recorder, and DVD player that 
has an

 terminal.

• When performing operations with

-connected 

components using the

 system, do not use the 

remote zone (Zone 2).

• For remote control operation, the audio connection 

cables must also be connected.

• If a component has two

 terminals, you can use 

either one to connect to the TX-NR801/TX-NR801E. 
The other one can be used to daisy chain with another 
component.

• With Onkyo DVD players, you can enter the pre-

program code so that you can operate the DVD player 
directly with the remote controller without connecting 
the

 terminals (See page 82).